Advertisement
TROUBLESHOOTING GUIDE
PROBLEM
Engine will not start.
Engine starts, but helicopter will
not fly.
Helicopter takes off, but spins
rapidly and crashes.
Helicopter takes off, but banks
sharply and crashes.
Helicopter will not attach to pump.
Important Safety Information
Keep propeller clear from face, eyes and fingers. Do not launch
at people or animals.
Pay Attention: Make sure people around you know you are
playing with AIR HOGS
launching. Use only the pump included in this package. Other
pumps may damage the helicopter or lead to injury. Never
pump anything except air into the engine. Do not leave air in
the helicopter.
After your last flight, spin the propeller to make sure all the air
IMPORTANT
© 2003 Spin Master Ltd. All rights reserved.
AIR HOGS® is a registered trademark of Spin Master Ltd. All rights reserved.
SKY COMMANDER™ is a trademark of Spin Master Ltd. All rights reserved.
Asst#45049
Item# 45055, 45056
REV 0
1. No air in tank.
2. Air Intake on helicopter or Pump
Nozzle are clogged with dirt.
3. Rotor is not spinning.
1. Air Tank is not full.
2. Tail Wing is not attached.
1. Tail Wing is not properly
assembled or has fallen off.
1. Incorrect launching technique.
1. Air Intake on helicopter or Pump
Nozzle are clogged.
®
. Point helicopter away from face when
ADULT SUPERVISION RECOMMENDED.
PLEASE DO NOT RETURN AIR HOGS® TO THE STORE.
CALL OUR FRIENDLY FLIGHT TECHNICIANS TOLL-FREE AT:
CAUSE
has been used up. Only use your AIR HOGS
grassy, open areas. To stop the propeller, gently touch the nose
cone to the grass.
Do not fly in very windy conditions. Do not fly helicopter in
temperatures below 45˚F/7˚C or the wings will become brittle
and may break, and engine performance will decrease.
Do not fly near overhead wires.
Do not leave your Sky Commander
extreme heat for excessive amounts of time.
SOLUTION
1. Pump up helicopter 50 times on an empty
tank to reach MAXIMUM air pressure
2. Remove dirt with a toothpick and re-pump.
3. After pumping is complete, spin the rotor
in the direction shown by the arrows to
start the engine.
1. On an empty tank, pump 50 times to
each for best performance.
2. Attach the Tail Wing to the helicopter
(see ASSEMBLY instructions above).
1. Be sure to slide the Tail Wing all the way
into the Tail Wing holder. Then, cover
both sides of the tail wing holder with
1. Always launch the helicopter by giving it
a gentle toss straight upwards. Tossing on
even a slight angle may cause the
helicopter's flight to be unstable and
banking to occur.
1. Use a toothpick to gently remove debris.
TM
in direct sunlight and/or
1-800-622-8339
®
helicopter in
TM
Advertisement
