Fanimation KUTE 52 FPD8534 Series Instructions Manual page 14

How to Operate Your Ceiling Fan (Continued)
4. To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting
process. If not used for long periods of time, remove
battery to prevent damage to transmitter. Store the
remote away from excessive heat or humidly.
(Figure 4)
WARNING
Chemical Burn Hazard. Keep batteries away from
children.
5. To set the remote code with a small screwdriver or
ball point pen (neither included), slide dip switches
firmly up or down. (Figure 5)
NOTE: Factory setting is all up. Do not use this
position.
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
6. Replace battery cover on the remote control with
previously removed screw by screwdriver. (Figure 6)
3V CR2032
Battery (2 pcs)
Remote
Control
Dip Switch
14
Figure 4
Figure 5
Figure 6