Advertisement
Item Description
already listed as a separate item above)
Components and parts containing toner and ink,
including liquids, semi-liquids (gel/paste) and toner
Components and waste containing asbestos
Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components and
materials requiring selective treatment can be removed.
Tool Description
Screw driver of "+" type
Hexagonal nut screw driver for DVI and D-SUB connector
Scraper
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment
including the required steps to remove the external enclosure:
1. Lay the monitor on a flat, soft and clean surface. (NOTE: The model using the curved surface screen, avoid crack)
2. Remove the screws by screw driver, to remove base; and then stand.
3. Use scraper to open all the latches along the edge of the Rear Cover;
4. Lift the Rear Cover and disconnect the connector to remove the Rear Cover
5.
6.
7.
8.
9.
10. Separate the panel, bezel and rear cover.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items contained
in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision C
Last revalidation date 09-May-2018
Notes
Include the cartridges, print heads, tubes, vent
chambers, and service stations.
HPI instructions for this template are available at
EL-MF877-01
Quantity of
items
included in
product
0
0
0
0
Tool Size (if
applicable)
200mm
200mm
Page 2
Advertisement
