Installation
Indoor Preliminary Setup
SETTING THE HD PTZ CAMERA UP INDOORS ON THE NETWORK IS ESSENTIAL FOR THE
SUCCESSFUL OUTDOOR INSTALLATION OF YOUR CAMERA.
Network Requirements: Port 21 TCP outbound for FTP images must be
open for the internal IP address of the camera.
Port 80 TCP inbound must be open in order to operate the camera and view
streaming data from any computer.
A web broswer must be installed on the computer used for retrieving the IP
address of the camera and it also must be installed on the computer used
for viewing live images from the camera.
By following these preliminary steps you will have the ability to obtain the internal IP
address of the HD PTZ Camera, which you need in order to view the live video
transmitted from the HD PTZ Camera. It is imperative that you install the camera indoors
initially in order to guarantee that the camera is working as it should.
In order to test the camera indoors the following supplied equipment will be needed:
HD PTZ Camera
Camera Mounting Arm
200 ft Ethernet Cable
HD PTZ PoE + Injector
Network Surge Suppressor
10 ft Ethernet Cable
Access to a computer running on the same subnet as the network connection that will be used
to connect the camera to for this test is needed. An electrical outlet needs to be nearby as well
along with your T30 bit/driver and a small screwdriver or pyliers.