Advertisement
Slide the metal handle inner into the black plastic cover.
Place the case down as shown in Fig 1 with the ventilation slots uppermost. The handle fixes to the 2 holes along the
centre of the case.
Place one of the handle fixings on one end of the handle. Place it on the case and align the holes. See fig 2
Fig 2
Place one of the handle fixing screws through the fixing, through the handle and through the case.
On the inside of the case fit one of the handle fixing nuts (with integral washer). Leave nut loose.
Fix the other end of the handle in the same way.
When both ends are fixed tighten the nuts until the screw thread is flush with the back of the nut.
Fig 3
43-TV-33-62 iss.1 GLO Oct 06 UK
3
Advertisement
