Control Commands - AOR ARD9800 Instruction Manua

Control Commands

Interfacing to a PC
Using the supplied PC interface cable, connect between the COM connector at the rear panel (marked
as [10101] ) to the serial port of a PC.
NOTE: Be sure your PC's serial port is active. Check for correct hardware and software settings!
Below are the pin assignments of the COM connector of the ARD9800.
ARD9800 COM connector
T erminal Settings
Pin #
1 --------------------------
2 --------------------------
3 --------------------------
4 ---------------------------
5 ---------------------------
6 ---------------------------
7 ---------------------------
8 ---------------------------
GND ---------------------------- GND
Communication Speed: 9600 bps
Data Length:
Start Bit:
Stop Bit:
Parity:
Flow Control:
Local Echo:
Specifications:
Serial connector of a PC (D-Sub 9 – pin)
Pin #
2
6
4
5
3
8
7
1
8 bit
1
1
None
Hardware
None
RS-232C compatible
23