Keystone KSTAP12B Instruction Manual page 17

Operation
Other features
FOLLOW ME/TEMP SENSING feature(optional)
NOTE:This feature can be activated from the remote control ONLY. The remote control serve-
sas a remote thermostat allowing for the precise temperature control at its location.
To activate the Follow Me/Temp Sensing feature, point the remote control towards the unit and
press the Follow Me/Temp Sensing button. The remote display is actual temperature at its
location. The remote control will send this signal to the air conditioner every 3 minutes interval
until press the Follow Me/Temp Sensing button again. If the unit does not receive the Follow
Me/Temp Sensing signal during any 7 minutes interval, the unit will beep to indicate the Follow
Me/Temp Sensing mode has ended.
AUTO-RESTART
f the unit breaks off unexpectedly due to the power cut,it will restart with the previous function
setting automatically when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not be restarted operation in the first 3 minutes. This is to
protect the unit. Operation will automatically start after 3 minutes.
AIR FLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically. Adjust the air flow direction automatically (NOTE:
On some models the louver can be adjusted manually only) :
-When the Power is ON, the louver opens fully.
-Press the SWING button on the panel or remote controller to initiate the Auto swing feature.
The louver willl swing up and down automatically.
-Please do not adjust the louver manually.
Water drainage
-During dehumidifying modes, remove the upper drain
plug from the back of the unit, install the drain connec-
tor(5/8" universal female mender) with 3/4" hose(locally
purchased). For the models without drain connector,
just attach the drain hose to the hole. Place the open
end of the hose directly over the drain area in your
basement floor.
Remove the
upper drain plug
Continuous
drain hose
12
√