Rack Mounting - Sony VSR-2000A Installation Manual

1-6. Rack Mounting

1-6. Rack Mounting
c
Install the unit in a stable location.
If the unit is mounted on a unstable table or slant bench,
the unit can fall and result in physical injury.
c
Use the specified support angle.
If the parts other than the specified one are used, the unit
can fall and results in physical injury.
This unit can be mounted in a 19-inch standard rack of EIA
standard. To mount the unit in the rack use the specified
rack mount kits and parts.
n
Mount the unit in the rack with the HDD removed from the
unit.
Specified rack mount kit : RMM-2000 (option)
Constituent parts
. Outer Support Assembly
Outer Support
Bracket
Screw (B4 x 8)
Inner Support
. Plate Nut
. Screw (B4 x 12)
. Screw (B4 x 8)
The following parts are supplied for rack mounting.
. Rack mounting screw (RK5 x 14)
. Rack mounting ornamental washer
n
Standard Tightening Torque
Screw Size Standard Tightening Torque
M3.0 0.7 to 1.0 N.m (7 to 10 kgf.cm)
M4.0 1.2 to 1.6 N.m (12 to 16 kgf.cm)
1-8 (E)
2 pcs
2 pcs
4 pcs
8 pcs
2 pcs
4 pcs
8 pcs
10 pcs
4 pcs
4 pcs
1. Turn off the power of the rack mounted unit incorpo-
rating the HDD.
2. Remove the four screws at the both sides of the unit,
and remove the four foot-holder assemblies while
lifting up the unit.
3. Attach the two inner supports to the side panels of the
unit.
Inner support
B4 x 8
4. Loosen the four screws of the outer support assembly
to slide the brackets.
Bracket
B4 x 8
B4 x 6
Foot-holder
assembly
B4 x 8
Bracket
B4 x 8
Outer support assembly
VSR-2000A