Table of Contents
Advertisement
1-5. Rack Mounting
Explains how to mount this unit into a 19-inch standard rack.
Be sure to mount this unit into a rack accurately following
the procedure and notes mentioned below.
c
. Use the specified rack mount rail.
The use of other rail of low strength may drop the unit
and cause the risk of injury.
. To prevent toppling over the rack, fix it on the horizontal
and firm floor securely with bolts, etc.
. Mount the unit into a rack with a steady posture.
m
. When other equipment with built-in hard disk drive is
already mounted in the same rack for mounting this unit,
turn off the power of the equipment before mounting this
unit.
. Adjust the temperature inside the rack within the range
of the unit’s operating temperature.
(Refer to Section 1-2.)
. Connect long enough cables on the connector panel,
considering that the unit is pulled out from the rack.
When the unit is mounted in a rack, the maximum
traveling distance is illustrated below.
581 (Maximum traveling distance)
Distance to the center of the side rail
Height of the unit mounted in a rack
Unit : mm
1-5. Rack Mounting
Required Parts
Use the specified parts for rack mounting.
The other supplied parts are not used.
. Rack Mount Rail RMM-30 (Option)
Slide rails with brackets ............................... 2
Screws (B5 x 8) ........................................... 8
Plate nuts ...................................................... 2 (Not used)
Screws (PWH4 x 10) ................................... 2 (Not used)
n
RMM-30 can be used for a rack with a depth of 660 -
3
830 mm (26 - 32
/
inches) for 22” rail.
4
660 - 830 mm
Front
Rear
3
(26 - 32
/
inches)
4
. Rack Mount Bracket SXA-2U (Option)
Rack angles .................................................. 2
Screws (B4 x 10) ......................................... 4
Screws (RK5 x 20) ...................................... 4
Polyamide washers ....................................... 4
Ornamental washers ..................................... 4
. Supplied with the RM-PP1
Screws (B4 x 8) ........................................... 8
n
The RM-PP1 contains ten screws, but the two screws of
them are spare.
1-3
Advertisement
Table of Contents
