Honeywell UDC 6300 Replacement Instruction
  1. Manuals
  2. Brands
  3. Honeywell Manuals
  4. Controller
  5. UDC 6300
  6. Replacement instruction
Honeywell UDC 6300 Replacement Instruction

Honeywell UDC 6300 Replacement Instruction

Process controller upgrade prom
Hide thumbs Also See for UDC 6300:
1
2
3
4
5

Advertisement

Table of Contents

Document Number

Kit contents

Equipment needed

11/99
UDC 6300 Process Controller
Upgrade PROM
Form: 51-52-33-85C
Effective: 11/99
Supersedes: 3/99
This kit contains one of the following Upgrade PROMs
Description
Adaptive Tune
Adaptive Tune + Math
Adaptive Tune + 2 Loops + Cascade
All Options
TPS Integration
Modbus RTU
Basic PROM
• Phillips Head Screwdriver
• Flat Bladed Screwdriver
• Small Pliers
Kit Instruction 51-52-33-85C
Part Number
51450900-501
51450900-502
51450900-503
51450900-504
51309350-501
51309350-502
51309181-501
Continued on next page
1 of 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UDC 6300 and is the answer not in the manual?

Questions and answers

Related Manuals for Honeywell UDC 6300

Summary of Contents for Honeywell UDC 6300

  • Page 1 UDC 6300 Process Controller Upgrade PROM Replacement Instruction Document Number Form: 51-52-33-85C Effective: 11/99 Supersedes: 3/99 Kit contents This kit contains one of the following Upgrade PROMs Description Part Number Adaptive Tune 51450900-501 Adaptive Tune + Math 51450900-502 Adaptive Tune + 2 Loops + Cascade...
  • Page 2 Replacement Instruction, Continued How to remove the Refer to Figure 1 for reference and follow the procedure listed in Table 1. chassis Table 1 How to Remove the Chassis Step Action Pull down the flap covering the front screw and loosen the screw. Grasp the bezel and pull the chassis out of the case.
  • Page 3 Replacement Instruction, Continued How to install the PROM Table 1 How to Install the PROM Step Action The PROM is located on the MCU/Input printed wiring board at location U109. See Figure 2 for location. If a Communications Board is not present: Lay the chassis on its left side on a non conductive surface Insert a small screwdriver under the PROM and lift up to remove.
  • Page 4 Replacement Instruction, Continued How to remove the In order to access the PROM if your controller has a Communications Bezel/Keyboard/ Board, you must remove the Bezel/Keyboard/Display assembly from the Display assembly chassis and access the printed wiring boards. The procedure in Table 2 lists the steps required to remove the Bezel/Keyboard/Display assembly.
  • Page 5 Replacement Instruction, Continued Follow the procedure in Table 3 to access the PROM. How to install the PROM Table 3 Access the PROM Step Action Remove the four screws (two on each side) that hold the two main printed wiring boards onto the chassis (See Figure 2 for location) Use pliers to squeeze the ends of the spacer and push it through the Power/ Digital I/O PWB.

Table of Contents