Advertisement
REPLACING
1.
Be sure surface
unit controls
are OFF.
\
Opening
Receptacle
/
2.
Line up opening
in the reflect&
bowl and
notch
in trim
ring with
the
surface
unit
receptacle.
3.
Hold the surface
unit as level
as possible
with
the
terminal
lust
started
into
the
receptacle.
4.
While pushing
the surface
unit terminal
into
the receptacle,
lift a little on the edge
of
the unit nearest the receptacle
5.
When the terminal
is pushed
into the re-
ceptacle
as far as it will go, the surface
unit
will fit into the reflector
bowl
Reflector
bowls
reflect
heat back
to the
utensils on the surface
units. They also help
catch
spills. When they are kept clean,
they
reflect heat better and look new longer.
If a trim ring gets discolored,
some of the
utensils
used
may
not be flat enough
Or
some may be too large
for the surface
unit.
In either case, some of the heat that IS meant
to go Into or around
a utensil
goes
down
and heats the trim ring. This extra
heat can
discolor
it
COOKTOP
1.
Be sure surface
units and cooktop
are cool.
2.
Carefully
lower the cooktop
onto the
Lift the front of the cooktop
at the center
support
rod. Be sure the tip of the rod fits in
and swing the support
rod up.
the notch in the cooktop.
3.
Wipe with warm soapy
water. Use soapy
steel wool pad on stubborn
spots.
DO NOT let the cookiop
bump the upper
oven when Illtlng.
DO NOT drop the tooktop.
Damage
can result.
13
Advertisement
