Advertisement
Quick Links
Soldering Flow Pot
Instruction Manual
Thank you for purchasing the HAKKO 487
Please read this instruction manual thoroughly
before operating the HAKKO 487.
Store the manual in a safe, easily accessible
place for future reference.
TABLE OF CONTENTS
1. CONSTRUCTION......................................................
2. OPERATION..............................................................
3. MAINTENANCE.........................................................
5. SPECIFICATIONS.....................................................
●
Soldering Flow Pot.
●
1
2
2
3
5
Advertisement
Related Manuals for Hakko Electronics 487
Summary of Contents for Hakko Electronics 487
-
Page 1: Table Of Contents
Soldering Flow Pot Instruction Manual ● Thank you for purchasing the HAKKO 487 Soldering Flow Pot. Please read this instruction manual thoroughly before operating the HAKKO 487. Store the manual in a safe, easily accessible place for future reference. ●... - Page 2 SAFETY PRECAUTIONS CAUTION When the power is on, the solder bath and the unit can reach high temperatures. The temperature of the melted solder in the solder bath is approximately 300℃ / 750 F. ° Mishandling may result in burns or fire. Please make sure to comply with the following rules. 1.
-
Page 3: Construction
1. CONSTRUCTION Motor Switch Temperature Control Meter Power Switch Connector for Foot Switch Solder Flow Outlet Table - 1 -... -
Page 4: Operation
Solder will flow when the foot switch is depressed. Note: The HAKKO 487 is factory-adjusted for use with 60Hz power sources. To use the HAKKO 487 with 50Hz power sources, open the rear panel of the unit, remove the pulley belt from the upper pulley and place it on the lower pulley. -
Page 5: Cleaning The Inside Of The Solder Bath
Stir solder in the bath thoroughly and melt it then scrape the oxidation on the surface of the solder. 2) Disassembling and cleaning the chamber The chamber should be cleaned once a month in order to ensure a smooth and even flow of solder at all times. 487 Body ① Pulley Belt ② Flannge Chamber ③... - Page 6 1) Turn the power switch on and melt solder in the bath for 30-40 minutes. 2) Remove most of the solder from the bath, leaving just enough so that it is at the level of the flange. Loose the hex screw ③(2.0mm, 0.07 in.) securing the flange. 3) Disconnect the power plug from the power outlet.
-
Page 7: Specifications
5. SPECIFICATIONS Name HAKKO 487 Power Consumption 850 W Temperature Control normal temperature ⁓ 300℃℉ (572℉) Bath Capacity approx. 15kg (33lbs.) Heating Element 400W×2 (cartridge heater) Outer Dimensions 330 (W) × 500 (D) × 250 (H) mm (13×19.7×9.8 in.) Weight approx. - Page 8 HEAD OFFICE 4-5, Shiokusa 2-chome, Naniwa-ku, Osaka 556-0024 JAPAN TEL: +81-6-6561-3225 FAX: +81-6-6561-8466 https: // www.hakko.com E-mail: sales@hakko.com OVERSEAS AFFILIATES U.S.A.: AMERICAN HAKKO PRODUCTS, INC. TEL: (661) 294-0090 FAX: (661) 294-0096 Toll Free (800) 88-HAKKO 4 2 5 5 6 https:// www.HakkoUSA.com E-mail: Support@HakkoUSA.com HONG KONG: HAKKO DEVELOPMENT CO., LTD.