Table of Contents
Advertisement
2 Insert the SAS expander end through the rear of the hard drive tray and align with the connectors on
the SAS expander board.
3 Attach the end of the CMA arm over the flange on the supporting wall and insert the CMA screw.
4 Grasp the cables on the remaining side and run them through the middle wall of the chassis.
5 Align the CMA arm with the screw hole on the rear of the chassis.
Figure 33. Installing the CMA in a hard drive tray
Table 22. Assembly material
Description
#6-32 screw
6 Connect the signal cable to either the PCIe raid or Mini PERC slots. This step is dependent on the
specific configuration.
7 Connect the power cable to the NPDB.
40
Installing and removing server components
Quantity
Torque (lbs/inch)
1
6 ± 0.2
Advertisement
Table of Contents
