Table of Contents
Advertisement
3 Locate the screw securing the CMA to the rear of the chassis and remove it.
4 Gently move back the CMA and pull out the cables from the server board side of the chassis. The
cables should now be on the tray side of the chassis.
5 Remove the CMA screw connected to the rear of the hard drive tray.
6 Disconnect the cables from the SAS expander board and pull them out of the hard drive tray.
7 Remove the CMA from the chassis. Make sure the cable ends do not catch on any components during
removal to avoid damaging the server or the cables.
Figure 31. Removing the CMA in the hard drive tray
Next steps
1 Install the CMA.
2 Complete the procedure listed in After working inside your system.
Related Links
•
Removing 3.5-inch hard drive from a tray
•
Removing 2.5-inch hard drive from a tray
•
Installing CMA in a hard drive tray
38
Installing and removing server components
Advertisement
Table of Contents
