Yamaha Disklavier E3 Series Maintenance Handbook page 40

3)-4. Key ppp adjust
3)-4-1.Start ppp adjust
3-2.Pedal HP Adjust
3-3.Calibration – Full
3-4.Key ppp Adjust ↓
The softest key stroke adjustment is started by enter button.
The buttons works in this adjustment as follows.
[Play/Pause][ENT]: to change mode between all and 1key mode.
[△][▽] or dial : to change the offset data
[REC]: to save the offset data. [STOP]: to quit the adjustment.
All mode: change the offset data of 88keys all at once.
Softest scale is played in the all mode.
[SELECT]: change the speed of scaling.
[←][→] cursor: Press the button in the direction of the
scaling to move to a scale which is higher or lower by
one octave.
Press the opposite button to change the direction of
scaling.
3)-4-2. Clear offset data
3)-5. Calibration – extra
3)-5-1. Sensor manual
3-3.Calibration – Full ↑
3-4.Key ppp Adjust
3-5.Calibration - Extra
3)-5-2. Key drive(0ne key)
3)-5-4. Key drive on, 3)-5-5. Key drive off
3-4-1.Start ppp Adjust
3-4-2.CLEAR offset data
3-4-1.Start ppp Adjust
3-4-2.CLEAR offset data
3-5-1.Sensor Manual
3-5-2.Key Drive(OneKey)
3-5-3.Key Drive ON
3-5-1.Sensor Manual
3-5-2.Key Drive(OneKey)
3-5-3.Key Drive ON
3-5-1.Sensor Manual
3-5-2.Key Drive(OneKey)
3-5-3.Key Drive ON
3-5-2.Key Drive(OneKey)
3-5-3.Key Drive ON
3-5-4.Key Drive OFF
[ ]move/adj.[ > ]mode
←→↑↓
ENT
[SELECT]speed [REC]save
Start
[ ]move/adj.[ > ]mode
←→↑↓
[SELECT]speed [REC]save
KEY=01 OFFSET=0 ALL
[ ]move/adj.[ > ]mode
←→↑↓
[SELECT]speed [REC]save
complete.
1key mode: change the offset data of the selected key.
Only the selected key is played during the 1key
mode.
[←][→] cursor: moves the selected key one by one.
3-4-2.CLEAR offset data
SURE? (PLAY,STOP)
Clears all the offset data of softest key stroke
adjustment
[REC] to save data
ENT
MANUAL MEASURE
SNS type : KS
Wait a moment.
Press all key to the end
If finished. Send BF 03
Sensor manual calibration.
Press down all the keys to end of the stroke.
[REC]: to save the data.
[STOP]: to quit the calibration.
[+][-]Select key:No01 A
[SELECT]Type:Std
[ENTER] to 'OK'
[ KD calibration ]
Model : E3 KS
One key calibration.
Select the key to calibrate by [+][-] or dial.
[SELECT]: to change between Std/Full.
[ENT]: to start the calibration.
Calibration to make the key- on table
Calibration to make the key- off table.
25
38