Yamaha Disklavier E3 Series Maintenance Handbook page 33

6-1.CTRL SHEET TEST
=TEST MODE=
MODEL:E3
PIANO:UPS
↓↑
=TEST MODE=
CTRL SHEET
(↓,↑,→)
← →
V2.00 Jan 22 2009
800 ENG REC UP S DB51
(1) LED Test
(2) OELD Test
(3) Sound Test
Press [PLAY]
(4) Switch Test
(Switch & Rmt Ctl)
(5) DRAM Test
Press [PLAY]
(6) Flash Read Test
Press [PLAY]
(7) Host I/O Test
Please wait
(8) MIDI I/O Test
(9) Calendar Test & Set
2008/07/31(Thu) 12:00:00
(↓)
Displays the Version number of CTRL sheet.
Model setting
[UP/DOWN]cursor: to select GP/UP, [REC]: "Quiet ON/OFF"
Check if LED lights up correctly.
(2) OELD Test
Check the organic electro luminescence display.
(3) Sound Test
1000
Press the [PLAY/PAUSE] button to execute the test.
Check the internal sound.
Press the buttons on the control unit and remote controller
to check the buttons.
(5) DRAM Test
wait 30 sec.
Press the [PLAY/PAUSE] button to execute the test.
DRAM test of the CTRL sheet will be executed and "OK" will be displayed if
no error is detected. It will takes about 30 seconds
(6) Flash Read Test
OK!
(7) Host I/O Test
Vendor=0499 ProdID=2003
Connect the [USB TO DEVICE] and [USB TO HOST] ports on the back
side of the control unit with a USB cable, and then execute the test.
Check the numbers shown above.
Connect the [MIDI OUT] and [MIDI IN] terminals on the back side of the
control unit with a MIDI cable and then execute the test.
Setting:
[ENTER] : setup mode ON/OFF
[REC] : Left item
[SELECT] : Right item
[UP/DOWN] : to change the value
(2) OELD Test
(3) Sound Test
Hz
(5) DRAM Test
31
18
2000 Hz
OK!