Saeco AULIKA EVO TOP HSC Operation And Maintenance page 52

US English
MENU ITEM
Off
On
Default
steam
Off
On
Machine Menu
General Menu
Tone
Off
On
Ecomode
Off
On
Stand-by Settings
15 minutes
30 minutes
60 minutes
180 minutes
Off
Coffee Ground Manage
Coffee grounds drawer full
alarm
Off
On
Coffee Grounds
Pre Grinding
Off
On
Set Temperature Offset
52
Description
Milk and coffee are dispensed in two separate steps.
NOTE:
in this case, the various dispensing stages (coffee or milk) can be individually stopped.
Milk and coffee are dispensed at the same time.
NOTE:
in this case, the user can only stop dispensing the beverage as a whole.
Setting ECOMODE to OFF brings down the dispensing time of mixed products.
The original standard values assigned by the manufacturer to each beverage can be reset.
After selecting this function, the customised individual beverage settings are deleted.
To enable/disable the machine's Steam function.
To disable the Steam function (it is not displayed in the list of "Extra" products, see "Extra Products"
section).
To enable the Steam function (it is displayed in the list of "Extra" products, see "Extra Products" section).
This menu manages general machine operation and maintenance parameters.
To change the machine operating settings.
This function allows you to activate/deactivate the acoustic alarms.
To deactivate the acoustic alarms.
To activate the acoustic alarms.
This function manages the activation of the machine boilers in order to save energy.
The function is set by default to «OFF».
This function activates all the boilers at every machine start-up to allow instant
preparation of all products.
In this mode, the power consumption is higher because the machine is always ready for
use.
In this mode, only the coffee boiler is activated at machine start-up.
The machine saves energy but needs longer time to dispense milk-based beverages.
The appliance is factory preset so that this setting is not enabled by default.
To set the time interval for the machine to go into stand-by mode after the last brewing.
The default time value is «after 30 minutes».
Once the set time has elapsed, the machine goes into stand-by mode.
Press any button to turn the machine back on.
After performing the function diagnostics and the warm-up phase, the machine is again
ready for use.
When this parameter is set to "OFF", the machine stays active.
This function allows you to manage the coffee grounds produced by the machine.
It is possible to set the machine so that it alerts the user when the coffee grounds drawer
needs to be emptied as it has reached the maximum number of grounds set under the
"Coffee Grounds" function.
alarm disabled
alarm enabled
You can set the maximum number of grounds that the drawer can contain before requiring to be
emptied.
To activate the pre-grinding function for a coffee yet to be selected in order to speed up coffee brewing
time.
With this setting, the pre-grinding function is disabled.
With this setting, the pre-grinding function is enabled;
the first time it is used, the machine grinds the selected coffee as well as the one that will
be selected at a later stage, so as to instantly brew the next coffee.
It is possible to increase/decrease the coffee temperature.