Table of Contents
Advertisement
DC-2000C SERIES ULTRASONIC THICKNESS GAUGE
8. Basic Operations
【8.1】Switch on
Select the probe and insert it into the probe socket and then press
switch on the instrument, the screen displays: the Series No. and the version
number.
If you did not insert the probe before switching on the instrument, the screen will
prompt you than "Please insert the probe", at this moment insert the probe into
the socket and waiting to go to the measuring status.
Notice: Please use the standard probe provided, otherwise the instrument will
does not work normally and displaying "Error".
【8.2】Probe Zero
The gauge does an automatic zeroing of the probe thus eliminating the need for
an on-block zero. Switch on the instrument, then the gauge came into the
measurement mode directly.
If customer feel the measurement value is incorrect during the measurement,
please put the probe in the air, and preess
Notice: Please make sure the probe is not coupled to the test piece when the
gauge is first turned on and that there is no couplant on the end of the probe.
The probe should also be at the room temperature, clean without any noticeable
wear.
【8.3】Backlight
Press
to turn on / off the backlight. (Under measurent state)
for zero calibration ay any time.
7
to
Advertisement
Table of Contents
