Page 1
VRX/VPR Rear Terminal Cover (51404897-501) Instruction Sheet Document: 43-DR-33-51 Revision: Effective: 12/98 Supersedes: Nothing Kit Contents Part Rear Cover Standoffs Lock washers Screws Rubber Grommets Materials needed Phillips screwdriver Grounded ESD wrist strap or ESD-safe work area Precautions • Wear a grounded ESD strap when handling parts.
Page 2
Figure 1 Rear Terminal Cover Rear Terminal Cover Installation Procedure Step Action Disconnect power to the instrument. With a screwdriver or sharp pointed instrument, remove centers from the 4 rubber grommets (part 97). Insert the grommets into the 4 slots in the rear cover (part 95). On the rear of the instrument, one at a time remove each screw from a corner of the rear terminal board and replace it with a lockwasher (part 98) and standoff (part 96).