Advertisement
Step
Disconnect power to the instrument.
1
With a screwdriver or sharp pointed instrument, remove centers from the 4 rubber grommets (part 97).
2
Insert the grommets into the 4 slots in the rear cover (part 95).
3
On the rear of the instrument, one at a time remove each screw from a corner of the rear terminal board
and replace it with a lockwasher (part 98) and standoff (part 96).
4
One at a time, disconnect instrument wires at the terminals and feed each wire outside in through the
most convenient grommet. After feeding a wire through, reconnect it to its terminal.
Attach cover to standoffs with screws (part 2).
5
Page 2 of 2
Figure 1 Rear Terminal Cover
Rear Terminal Cover Installation Procedure
Action
43-DR-33-51
Advertisement
