Electrical Installation - Dimplex DIR Series Installation Manual

Electrical Installation

WARNING: This Heater MUST
be permanently installed and hard
wired by an authorized / licensed
electrical professional. Do not
perform maintenance or carry out
installation or assembly procedure
while electrical power is switched on.
CAUTION: A circuit breaker is
required for proper installation. Do
not load beyond 80% capacity. The
type of circuit breaker must be C
curve type.
1. DIR15A10GR (1500W) is
designed for connection to the
120V~ 60Hz electric mains
equipped with a grounding wire.
2. DIR18A10GR (1800W),
DIR22A10GR (2200W) and
DIR30A10GR (30000W) heater
is designed for connection to
the 240V~ 60Hz electric mains
equipped with a grounding wire.
14
3. The heater must not be located
immediately below an electrical
connection. Power point should
not be located at the back of the
heater. The power point needs to
be located outside the physical
footprint of the heater to minimize
heat build-up behind the heater.
4. If the heater is to be mounted on
an incline (e.g. Vaulted ceiling),
ensure the electrical connection
point is below the heater.
dimplex.com