Dimplex DIR Series Installation Manual page 3

Heater Installation
combustibles at least 0.9 m (3 ft)
from the front of the heater and
away from the side and rear.
5. The heater is designed for
outdoor and indoor use and
should not be used for any
other purpose. Any other use
not recommended by the
electric shock, or injury to
persons.
6. Before commencing installation
make sure the electrical supply
voltage is the same as that
shown on the rating plate of the
heater.
7. The heater must be mounted at
least 2.4 m (8 ft) above ground
level. For other clearance please
refer to the diagram included in
these instructions.
store or use gasoline or other
the vicinity of the heater
9. The heater is not intended for
use in bathrooms, laundry areas
or similar indoor areas. Never
locate heater where it may fall
into a bathtub, pool, spa, or other
water container.
10. Do not install the heater directly
near a bathtub, shower or
swimming pool. Any switches
8
or controls must not be within
reach of a person in the
bathtub, shower or swimming
pool.
11. Ensure that the heater had been
mounting position.
12. The heater can be only installed
horizontally.
13. DO NOT install the heater
vertically. Failure to do this
may cause the heating element
within the tube to sag and
cause premature burnout.
14. There are no user-serviceable
parts inside the heater. Any
servicing other than regular
cleaning of the heater should
be performed by an authorized
service professional.
WARNING: The heater must
not be used if the glass panels
are damaged.
!
NOTE: This heater comes with
a pair of stainless steel adjustable
angle mounting brackets.
The adjustable angle enables
the heater to be installed on
horizontal and inclined surfaces.
dimplex.com