Advertisement
The AL2400AC will not connect to my network! (Repeater / Client mode)
If you have any problems connecting your AL2400AC please check below steps.
1. Placement
AL2400AC will work partially/not work if you place it outside of the coverage of your wireless network.
To see the status of the received signal on AL2400AC, please see page 16.
We recommend that you place AL2400AC near your exisiting wireless router when set it up.
2. Selected network
Please make sure you select the correct wireless network when setup AL2400AC.
Normally you will find the name of your wireless network on the router label.
3. Encryption key
Please meake sure you enter correct encryption key when setup AL2400AC.
Normally you will find the encryption key for your wireless network on the router label.
Note! If you have changed the encryption key by yourself you need to use this one.
If you have any problem when setup AL2400AC we recommend you to reset it back to factory default,
and then start the setup process over again.
? ?
Internettmodem
5VDC
WiFi
ON / OFF
Reset/WPS
4
3
2
1
Internet
15
Advertisement
