Table of Contents
Advertisement
Installation and operating manual
6. Maintenance and servicing
DANGER
Insufficient qualification
Improper handling and operation of the device might result in serious or even fatal injury, and/or
serious damage to property.
•
Recommended interval: 1x per year
Wearing parts kit to be used:
BEKOMAT
®
8
2000450
BEKOMAT
®
9
4005382
Preparation:
•
Close inlet
•
Press TEST button until BEKOMAT
•
Disconnect BEKOMAT
®
6.1. Maintenance schedule
Maintenance
Function test
•
Press the TEST button
•
Visual inspection
Maintenance
•
Replace wearing parts (kit)
•
Perform leakage test
•
Perform function test
•
Check adhesive label and replace, if necessary
•
Check valve core length
•
Check cable connections
•
Clean
Function test:
We strongly recommend performing a daily function test of the BEKOMAT
•
To test the solenoid valve, press the test button briefly (for approx. 2 seconds).
The BEKOMAT
starts a manual drain cycle.
®
•
To test the alarm function, close the condensate inlet and press and hold the test button for approx. 1 minute.
The BEKOMAT
starts a manual drain cycle and triggers an alarm.
®
During this test, large volumes of compressed gas might enter the condensate collection line.
Maintenance:
For more information regarding the maintenance of the device, contact the manufacturer.
20
All maintenance tasks must be performed by service personnel of BEKO TECHNOLOGIES GmbH or
an authorised BEKO partner.
is depressurised
®
from power supply
daily
annually
.
®
Interval
BEKOMAT
EN
8/9
®
Advertisement
Table of Contents
