Husqvarna AUTOMOWER 550H Operator's Manual page 42

Message Cause
Wheel motor over-
Grass or other objects is wound around
loaded
the drive wheel.
Charging station The contact between the charging
blocked
strips and contact strips may be poor
and the product has made a number of
attempts to charge.
An object is obstructing the product.
The charging station is tilted or bent.
Stuck in charging
The product slips on the baseplate.
station
There is an object in the way of the
product preventing it from leaving the
charging station.
Upside down
The product is leaning too much or has
turned over.
Mower tilted
The product is tilted more than the
maximum angle.
Needs manual
The product is set to the
charging area operating mode.
Next start hh:mm
The schedule setting prevents the
product from operating.
The clock on the product is not correct.
Lifted
The lift sensor is engaged because the
product hit an object or/and is blocked.
Collision sensor
The body of the product can not move
problem, front/rear
freely around its chassis.
The product has become stuck.
Wheel motor
Grass or other object is wrapped
blocked right/left around the drive wheel.
42 - Troubleshooting
Action
Examine the drive wheel and remove
grass or other objects.
Put the product in the charging station
and check that the charging plates and
contact plates make good contact.
Remove the object.
Confirm that the charging station is
placed on a fully flat and horizontal
ground. The charging station must not
be tilted or bent.
Clean the baseplate.
Remove the object.
Turn the product the right way up.
Move the product to a flat area.
Secondary
Place the product in the charging sta-
tion. This behavior is normal and no ac-
tion is required.
Change the schedule settings. Refer to
Schedule on page 25 .
Set the time. Refer to
page 30 .
Free the product. If the problem stays,
speak to your approved servicing deal-
er.
Remove dirt or objects between the
chassis and the body to make sure that
the body can move freely around the
chassis.
Free the product and rectify the reason.
Clean the wheels and around the
wheels.
Time & date on
1457 - 001 - 29.01.2020