Husqvarna AUTOMOWER 550H Operator's Manual page 26

The schedule function controls which hours the
product should operate and not operate. When
the product is not operating it is parked in the
charging station. The operating hours and days
can be seen in an overview in the Automower
Connect app.
The default schedule setting allows the product to
operate around the clock 7 days a week. This is
normally a suitable setting for a work area
corresponding to the maximum capacity. If the
work area is less than the maximum capacity the
schedule should be used to minimize wear on the
grass and to the product.
To calculate the schedule setting, refer to
calculate the schedule setting on page 26 .
3.11.1.1 To edit the schedule settings
Settings > Schedule > Edit in the app.
1. Select
2. Select the pencil symbol in the app.
3. Select which days of the week and hours the
product must operate.
Save .
4. Select
3.11.1.2 To add a new schedule setting
Settings > Schedule > Edit in the app.
1. Select
2. Select the plus sign in the app.
3. Select which days of the week and hours the
product must operate.
Save .
4. Select
3.11.1.3 To calculate the schedule setting
1. Calculate the dimension of your lawn in m
2
ft .
2 2
2. Divide the m / ft of the lawn with the
approximate operation capacity. Refer to
table below.
3. The result is equal to the number of hours
that the product must operate each day.
Note: The operation capacity is approximate and
is calculated for flat and open work area. If the
work area has a lot of slopes or obstacles, you
Schedule settings.
need to increase the
Model Approximate operation ca-
pacity, m
®
Automower 208 / 2240
550H
26 - Installation
Example: A lawn of 1000 m
an Automower
1000 m
®
10700 ft
Days /
week
7
3.11.2 Operation
To
3.11.2.1 Spiral cutting
If the product enters an area where it senses the
grass is longer than average, it can change the
movement pattern to
that the product mows in a spiral pattern to faster
cut the area with longer grass. It is possible to set
the intensity of the
intensity means that
often.
cutting begins more often.
Note:
area mode. Cutting in the Secondary area mode
does not let the product to start
Spiral Cutting does not start in slopes steeper
than 15%.
2
/
1.
2 2
/h / ft /h
2.
3.
2
/ 10700 ft
®
550H.
2
/ 208 ≈ 5 h.
2
/ 2240 ≈ 5 h.
h / day Schedule settings
5 07:00 - 12:00 / 07:00
am - 12:00 pm
In the Operation's menu it is possible
to change the settings of the
timer, ECO mode and Spiral cutting .
Spiral cutting . This means
Spiral cutting . Very low / Low
Spiral cutting begins less
High / Very high intensity means that Spiral
Spiral cutting is only started in the Main
Select Settings > Operation in the app.
On/Off to enable or disable Spiral
Select
cutting .
Settings > Spiral Cutting > Use >
Select
Intensity to select the level of the function.
1457 - 001 - 29.01.2020
2
, cut with
Weather
Spiral cutting .