Husqvarna AUTOMOWER 550H Operator's Manual page 27

Save .
4. Select
3.11.2.2 Weather timer
Weather timer automatically adjust the
The
cutting time to the growth of the grass. The
product is not permitted to operate more than the
schedule settings.
Weather timer , it is
Note: When using
recommended to make as much operating time
as possible available for the
not restrict the schedule more than necessary.
The first operation of the day is set by the
schedule settings. The product always complete
1 mowing cycle, and then the
selects if the product will continue to operate or
not.
Weather timer is reset if the product
Note: The
does not operate for more than 50 hours, or if a
Reset of all user settings is done. The Weather
timer is not changed if a Reset of schedule
settings is done.
To set the Weather timer
Settings > Operation in the app.
1. Select
on/off to enable or disable the
2. Select
Weather timer .
Note: If the cutting results are not
satisfactory, the cutting time can be
adjusted. Set the cutting time
Low to cut for a shorter
a longer time or
time.
Save .
3. Select
3.11.2.3 ECO mode
ECO mode is activated, it switches off the
If
signal in the boundary loop, the guide wire and
the charging station, when the product is parked
or is charging.
ECO mode to save energy and avoid
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
Note: To start the product manually in the work
area, push the STOP button before you remove
1457 - 001 - 29.01.2020
the product from the charging station. If not, the
product can not be started in the work area.
To set the ECO mode
1.
2.
3.
Weather timer . Do
3.11.3 Installation
Weather timer
3.11.3.1 To find the charging station
The product can be set to search for the charging
station in 3 methods:
•
•
•
The factory setting is set to use the 3 search
methods at the same time. Use the factory
setting to find the charging station as fast as
possible and to keep the risk of tracks on the
lawn to a minimum. The product always starts to
search for the
specified time interval, it also uses
and
Causes why the product cannot follow the wire:
High to cut for
•
•
To change the signal range of the charging
station
For some installations it is necessary to decrease
the signal of the charging station. For example
when the charging station is put near an obstacle
such as a bush or wall and the signal reaches to
the other side of the obstacle. The product knows
that it is close to the charging station and tries to
dock, but the objects prevents it. The options are
min , avg (average) or max .
Settings > Operation in the app.
Select
on/off to enable or disable the ECO
Select
mode function.
Save .
Select
In the Installation menu it is possible to
adapt the settings of the product for
best mowing result.
Charging station signal
Follow boundary wire
Follow guide wire
Charging station signal . After a
Follow boundary wire .
Obstacles near the wire have not been
isolated.
The charging station, the boundary wire or
the guide wire are not installed according to
the instructions in To install the charging
station on page 20 , To install the boundary
wire on page 21 and in To install the guide
wire on page 22 .
Follow guide
Installation - 27