Husqvarna AUTOMOWER 550H Operator's Manual page 30

3.11.4 Accessories
Settings for accessories mounted on
the product can be made in this menu.
3.11.4.1 To avoid collisions with the mower
house
When this option is enabled, the wear on the
product and the house is reduced, but it can
result in more uncut grass around the charging
station.
Settings > Installation > Mower house
1. Select
in the app.
on/off to enable or disable the
2. Select
function.
Save .
3. Select
3.11.4.2 To set the ultrasonic
Ultrasonic is applicable for Automower
ensures that the product reduces speed before it
hits an obstacle. This function can be disabled,
which means the product will always operate at a
lower speed.
Settings > Installation >Ultrasonic in
1. Select
the app.
on/off to enable or disable the
2. Select
function.
Save .
3. Select
3.11.5 General (Bluetooth
This function is used to set time and
date, or to reset to default settings. To
change the settings, obey the
instructions in the Automower
Connect app.
3.11.5.1 Time & date
The time and date can be changed manually, or
by using the time and date from the mobile
device.
To set the time & date
Settings > General > Time & Date in
1. Select
the app.
Time & Date from phone or select the
2. Select
pencil to enter the correct time and date.
Save .
3. Select
30 - Installation
3.11.5.2 Reset to factory settings
The user settings can be reset to factory settings.
Note:
& Time will not be reset.
To reset to factory settings
1.
2.
3.11.6 Security (Bluetooth
®
550H. It
3.11.6.1 New loop signal
The loop signal is randomly selected to create a
unique link between the product and the charging
station. In rare cases, there may be a need to
generate a new signal, for instance if 2 adjacent
installations have a very similar signal.
To create a New loop signal
1.
®
only)
2.
3.
4.
®
3.11.6.2 To change the PIN code
1.
2.
3.
4.
5.
3.11.6.3 Theft protection
In the
the alarm duration and also what events should
PIN code, Loop signal, Messages and Date
Settings > General > Reset in the
Select
app.
Reset to factory settings .
Select
®
The security settings controls the PIN
code, the GeoFence and other security
functions. To change the settings,
obey the instructions in the
®
Automower Connect app. The correct
PIN-code must be entered to get
Security menu in the
access to the
®
Automower Connect app.
Put the product in the charging station.
Security > New loop signal > Create
Select
new loop signal in the app.
Select Save .
Wait for confirmation that the loop signal has
been generated. This usually takes about 10
seconds.
Select Security > Change PIN code in the
app.
Enter the PIN code.
Enter the new PIN code.
Enter the new PIN code to confirm.
Make a note of the new PIN code in Memo.
Introduction on page 3 .
Refer to
Theft protection menu it is possible to set
1457 - 001 - 29.01.2020
only)