Crossber Installation; Universal Joint Repair; Assembly - Woods BATWING BW20.50QE Operator's Manual

1. Crossbar puller clevis
2. 5/8 NC x 4-1/2 HHCS
3. 5/8 NC Hex nut
4. Crossbar puller pad
5. Crossbar puller tube
6. Crossbar puller screw
7. Crossbar puller link
Figure 16. Crossbar Removal
MAN1279 (15/04/2019)
CROSSBAR INSTALLATION
1. Using emery cloth (220 or finer), remove surface rust, Loctite
foreign material from hub, splined gearbox vertical shaft, and crossbar

assembly.

2. Slide crossbar assembly (8) onto splined shaft. Install nut (69) and align a
slot with hole in splined shaft. Torque nut to 1084.65 N-m (800 lbs-ft).
3. Install cotter pin (70) through slot in nut and bend ends over.
8. Crossbar assembly
69. Castle nut, M30 x 2.0P
70. Cotter pin, 1/4 x 2-1/4
Figure 17. Crossbar Assembly Installation

UNIVERSAL JOINT REPAIR

1. Yoke
2. Cup and bearings
3. Snap ring
4. Journal cross
Figure 18. U-Joint Exploded View
U-Joint Disassembly
1. Remove external snap rings from yokes in four locations as shown in
Figure 19.
Figure 19
Dealer Service 25
®
and