Table of Contents
Advertisement
LIFT ARM
DRIVELINE ATTACHMENT
CAUTION
■ Make sure driveline will not bottom out at the
shortest length and that it has at least 4" overlap
at the longest length.
Attach the cutter to the tractor 3-point hitch (or quick
hitch if available). Do not attach driveline. Raise and
lower cutter to determine maximum and minimum dis-
tance between the tractor PTO shaft and the gearbox
input shaft. If the distance is too large, the driveline will
be too short for proper engagement. If distance is too
small, the driveline may bottom out in operation and
damage the cutter or tractor.
There must be at least 4 inches of engagement at the
cutter's lowest possible point of operation.
If driveline is too short, please call your Woods dealer
for a longer driveline.
The driveline must not bottom out when raised to the
maximum height possible.
If driveline is too long, please follow the instructions for
shortening the driveline.
MAN1298
( 08/01/2023 )
BREAK LINK
A-FRAME
HITCH PIN
Figure 2. Standard Hitch and Quick Hitch Configurations
OPTIONAL BREAK
LINK PIVOT POINT
1-1/4" OD SLEEVE
CD8110
INSTALLATION AND REMOVAL
OF DRIVELINE (TRACTOR PTO)
To Install:
Pull locking collar back and at the same time push
driveline onto tractor PTO shaft until locking device
engages.
To Remove:
Hold driveline into position, pull locking collar back, and
slide driveline off tractor PTO shaft.
Figure 3. Lock Collar
Operation 13
1-7/16" OD SLEEVE
(SUPPLIED WITH
QUICK HITCH)
Advertisement
Table of Contents
