30 Dealer Check Lists - Woods BATWING BW20.50QE Operator's Manual

PRE-DELIVERY CHECK LIST
(DEALER'S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to ensure it is set up properly
before delivering it to the customer.
The following check lists are a reminder of points to inspect. Check off each
item as it is found satisfactory or after proper adjustment is made.
■
Gearboxes are not filled at the factory. Prior to delivery, make sure
each gearbox is filled between lowest ring and end of dipstick with 80 or
90W API GL-4 or GL-5 gear lube.
___ Check that all safety decals are installed and in good condition.
Replace if damaged.
___ Check that shields and guards are properly installed and in good con-
dition. Replace if damaged.
___ Check all bolts to be sure they are properly torqued.
___ Check wheel bolts for proper torque.
___ Check that all cotter pins and safety pins are properly installed.
Replace if damaged.
___ Check that blades have been properly installed.
___ Check and grease all lubrication points as identified in lubrication infor-
mation on page 15.
___ Check the level of gearbox fluids before delivery. Service, if required,
as specified in the lubrication information on page 15.

30 Dealer Check Lists

DEALER CHECK LISTS
NOTICE
DELIVERY CHECK LIST
(DEALER'S RESPONSIBILITY)
___ Show customer how to make adjustments and select proper PTO
speed.
___ Show customer how to make sure driveline is properly installed and
that spring-activated locking pin or collar slides freely and is seated in
groove on tractor PTO shaft.
___ Show customer how to determine the turning limits of the CV PTO
driveline.
___ Show customer the safe, proper procedures to be used when mount-
ing, dismounting, and storing equipment.
___ Make customer aware of optional equipment available so that cus-
tomer can make proper choices as required.
___ Instruct customer how to lubricate and explain importance of lubrica-
tion.
___ Point out the safety decals. Explain their meaning and the need to
keep them in place and in good condition. Emphasize the increased
safety hazards when instructions are not followed.
___ Explain to customer that when transporting the cutter, the wing and
center sections should be raised and their respective transport bars
installed and pinned in place.
___ Present Operator's Manual and request that customer and all opera-
tors read it before operating equipment. Point out the manual safety
rules, explain their meanings and emphasize the increased safety haz-
ards that exist when safety rules are not followed.
___ Explain to customer the potential crushing hazards of going under-
neath raised equipment. Instruct that before going underneath to dis-
connect the driveline, securely block up all corners with jack stands
and to follow all instructions in the BLOCKING METHOD, page 15 of
the operator's manual. Explain that blocking up prevents equipment
dropping from hydraulic leak down, hydraulic system failures or
mechanical component failures.
___ Point out all guards and shields. Explain their importance and the
safety hazards that exist when not kept in place and in good condition.
___ Explain to customer that when towing on a public road to comply with
all state and local lighting/marking laws and to use a safety tow chain.
MAN1279 (15/04/2019)