Zeroplus Arduino starter kit with Logic Analyzer Manual page 77

PROCEDURE
• Connect the components as shown on the schematic.
• Connect the channel A0 of the logic analyzer to the anode of the
LED and the channels A1 to A5 of the Logic Analyzer to the pins
3 to 7 of the Arduino UNO board.
Logic Analyzer
Arduino UNO
• In ZP Studio, set the trigger to rising edge on A0, because the
signal is rising when the LED turns on, and that's what we want
to detect.
• In ZP Studio, create a bus with the channels A1 to A5.
• Click on Run.
• The value marked by the trigger bar is the one we are looking for.
This value is randomly generated everytime the board is reset.
A0 A1 A2 A3
LED 3 4 5
A4 A5 A6 A7
6 7
clk
76