Zeroplus Arduino starter kit with Logic Analyzer Manual page 32

PROCEDURE
Step 1:
• Connect a male-to-male jumper to one channel of the logic analyzer
and to one pin of the Arduino Uno as shown on the diagram.
Logic Analyzer A0
Arduino UNO 8
• Open the sketch containing the source code of this experiment and
upload it to the Arduino Uno.
• In the Arduino IDE open the serial monitor. .
• In the serial monitor enter 1, then click on Send.
• In ZP Studio, set the trigger to rising edge on the channel A0, the
sample rate at 100MHz
position to 10%
[3]
• Click on Run.
result:
A1 A2 A3 A4
, the trigger level to 2.5V
[1]
and the memory depth to 32kb.
A5 A6 A7 clk
, the trigger
[2]