Table of Contents
Advertisement
•
In the serial monitor, enter 2 and click on Send.
•
In ZP Studio, set the trigger to rising edge on the channel A1 and
keep other settings unchanged.
•
Now we need to group the channels into what is called a bus. Right
click on the channel A1 and select Add channel/bus. Click on Bus
and on Next, then use right arrow to select the channels that you
want to group together. Here select the channels A1 to A6 and click
on Next then on Finish.
•
Click on Run.
•
This is what you should see:
Advertisement
Table of Contents
Need help?
Do you have a question about the Arduino starter kit with Logic Analyzer and is the answer not in the manual?