Zeroplus Arduino starter kit with Logic Analyzer Manual page 61

PROCEDURE
• Connect the logic analyzer to the pins 3 to 9.
Logic Analyzer
Arduino UNO
• In ZP Studio, set the trigger to rising edge on the channel A0, the
sample rate to 25KHz, the sample depth to 32kb, the trigger level to
2.5V and the trigger position to 10%.
• In ZP Studio, create a bus with the channels A0 to A6.
• right click on the BUS you just created (BUS0) and select "analog waveform."
• In ZP Studio, select the Noise Filter to remove any transitional values,
as explained in the chapter Logic Acquisition and Software Tutorial.
• This is what you should
see (right):
• The values on the bus
channel represent
light intensity sensed
by the sensor.
A0 A1 A2 A3
3 4 5 6
the
A4 A5 A6 A7
7 8 9
clk
60