Operation; Heat And Blower Levels; Cooling Level; Ionisation Function - Silvercrest SHTK 2000 A1 Operating Instructions Manual

Operation

GB
NOTE
► Before use, pull the plug out of the device up to the point indicated with a
red mark!

Heat and blower levels

Cooling level

Ionisation function

8
1) Insert the plug into a power socket.
2) Switch the hair dryer on with the blower level switch 5.
The hair dryer is fi tted with two function switches. With these you can separately
select the strength of the air fl ow (blower level switch 5) and the level of heat
(heat level switch 6):
Blower levels
O The hair dryer is switched off
reduced air fl ow
full power air fl ow
Heat levels
cold air fl ow
low heating level
high heating level
3) After use, switch the appliance off in that you place the blower level switch 5
into position "O". Then remove the plug from the wall socket.
4) Press the cord retract button 2 to feed the cord back into the device.
With the cooling level button 7
every combination of blower and heat levels.
This hair dryer is equipped with an ionising function:
When drying the hair using a hair dryer, the hair takes on a static charge and
begins to "fl y".
The ionisation function ensures that this charging of the hair is neutralised and
cancelled. The hair becomes soft, supple, shiny and easier to style.
❄
you can produce a cooler air fl ow with
SHTK 2000 A1