Dimplex TRFB 150 Mounting And Operating Instructions page 5

GB
Mounting and Operating Instructions
TRFB 150 Electric Towel Warmer/Rapid Heater
1. Important Notices
Read
all information contained in this manual carefully.
Keep these instructions in a safe place and hand them
over, if applicable, to the next owner.
− The appliance is not intended for use other than in-
doors, for the heating of room air and for drying tow-
els, garments and similar textile goods.
− The appliance may only be installed by an authorised
qualified electrician.
− All repairs and interventions in the appliance may
only be performed by qualified persons or the cus-
tomer service.
− In the event of any defect (e.g. appliance or power
cord is damaged, unit is not working), the appliance
must be disconnected from the power supply. Deacti-
vate the circuit-breaker.
− In the event of extended periods of non-use, the
appliance must be disconnected from the mains
power supply
.
− Do not cover the heating appliance as
there is a risk of fire!
− Do not allow appliance to be operated
by children or other persons not capable of safely us-
ing the device. Children must be prevented from play-
ing with or near the appliance.
− Caution! The outside of the appliance gets hot when
in use.
− Do not use the appliance in areas where flammable
gases or liquids are stored or used.
− Caution! After the appliance has been switched on
automatically, there is a potential fire hazard as the
appliance may have been covered or obstructed prior
to switching on.
− Make sure that minimum clearances, in particular
from easily inflammable materials or heat-sensitive
plastic materials, are maintained (see Section "2.
Minimum Clearances")
− The supply cord must not be placed over the hot ap-
pliance.
2. Minimum Clearances, Mounting
The heating appliance may only be mounted and oper-
ated in vertical position on a vertical wall.
For the installation of heaters in rooms with a bathtub or
a shower, it is imperative that the national electrical
codes and regulations be adhered to.
The appliance must be installed in such a way that
switches and other controls cannot be touched by the
person using the bath or the shower.
Do not mount the appliance directly under an electrical
wall outlet.
The mains socket must be accessible after the appliance
has been mounted.
It is absolutely necessary that the minimum clearances
indicated in the mounting diagram be maintained.
Beyond that, a clearance space of at least 500 mm to
combustible materials is to be allowed in front of the ap-
pliance.
100
Mounting procedure:
The heater must be fixed to the wall using 3 screws (see
diagram).
1. Loosen the shipping bolt and remove wall bracket
from rear panel
2. Mark the location of the mounting holes for the wall
bracket. Ensure that the holes are horizontal.
3. Drill the holes, insert the wall plugs and secure the
wall bracket to the wall using 2 screws.
4. Unscrew the fixing screws for the securing plate, ro-
tate the plate 180 degrees and reattach it to the back
panel.
5. Engage heater in wall bracket and mark the drilling
hole for the securing plate.
6. Detach the heater from the bracket. Drill the hole for
the securing plate and insert the wall plug.
7. Re-engage the heater in the wall bracket and fasten
the securing plate to the wall.
177
1085 873
212
Front view. Dimensions in mm
5
trfb-gb_ba 11/07/A
200
100
250
440
111,5
217
Anschlussleitung 0,9 m
Supply cord 0.9 m