Run An All Stations Cycle; Turn On A Station Or Zone Manually; Stop All Watering; Change From One Running Station To Another - Toro EVOLUTION Series Quick Start Manual

Run an All Stations Cycle (ASC)
Running an All Stations Cycle is useful for troubleshooting a
sprinkler system.
1. Follow Step 1 above.
2. Press to move above
ALL".
to "T
EST
3. Press to start the run time
blinking.
4. Press or to set the run time.
All stations will run the same length of time, in sequence,
from lowest to highest possible.
Enter
5. Press to start. (Leave the transmitter on
during the ASC sequence.)

Turn On a Station or Zone Manually

1. Turn on the remote and press
station number desired.
2. Press once to move to run time.
3. Press or to set the station's one-time manual
running time.
Enter
4. Press to start the station. A flashing rain-drop
indicates a running station.
The controller may display a differing countdown. If so, it
has been overridden by the remote's countdown.
6
TEST
P- C
ALL
03
RUN MIN
TIME
Setup
Cancel Enter
or to scroll to the
Stop All
Press
Cancel
interrupted irrigation program.

Change from One Running Station to Another

1. Press or
2. Press once to move to run time.
3. Press or
Mode
4. Press
Enter
PWR (Hold)
running station will shut off .

Remote Auxiliary Operation

The controller is capable of controlling an auxiliary system
(such as a lighting system) using AUX devices. The EVO-HH
handheld remote can control the auxiliary system too.

Switch to Auxiliary Operation

1. Hold down the
button for a few seconds until
A U
" " appears in the screen.
2. Release the button. The remote is
in Auxiliary mode.
3. Set the PIN on the remote
(see page 5) to communicate
with the auxiliary controller.
. A slashed-out raindrop indicates an
to select the desired station.
to set the run time.
to start the station. The previously
PWR(Hold)
Mode
Setup
A U
Mode
PWR (Hold)