At The Remote; Set The Pin; Powering The Remote; Set The Number Of Stations - Toro EVOLUTION Series Quick Start Manual

At the Remote

Set the PIN

1. Press to turn on
PWR(Hold)
Mode
the remote transmitter.
2. Press twice. "SET
Setup
PIN" appears on the screen.
3. Press or to set the first
digit of the PIN number. Press
to move to the next digit.
4. Repeat step 3 to set the other
numbers in the 4-digit PIN.
5. Press to save the PIN.
Enter

Powering the Remote

• Press to turn on the remote.
PWR(Hold)
Mode
• Press and hold
PWR(Hold)
Mode
Turning off the remote does not turn off irrigation
operations in operation.
Automatic Power Down of Transmitter
The remote powers down after five minutes of button inactivity
to extend battery life.
SET
PIN
98 14
Mode
Setup
PWR (Hold)
Cancel Enter
about two seconds to turn off.

Set the Number of Stations

To save time using the remote, set the number of stations in the
transmitter to match the number of stations on the
EVOLUTION® Series controller. For example, for a 8-station
controller, set the transmitter to a station maximum of 8.
1. Press once to view
Setup
the Max Station screen.
2. Press or to set
the desired maximum station
number.
3. With the desired number
displayed, press
Start Program "A" or "B" or "C"
1. In manual station mode, press
P- A
highest station. "
Press again for "
P- C
" " (Program C).
2. With the desired Program displayed, press
sequential station run.
A remotely started program runs continuously.
SET
MAX
08
.
Enter
Setup
to go beyond the
" (Program A) appears.
P- b
" (Program B) or again for
Cancel
Mode
PWR (Hold)
Enter
for a
Enter
5