Braun Silk-epil Xelle 5270 Manual page 13

Cleaning the shaver head
6. After shaving, unplug the appliance
and, if necessary, remove the OptiTrim
attachment.
7. Clean the OptiTrim attachment with
the brush.
8. In order to clean the shaver head,
remove the shaving foil frame
To do so, press the release bars
the front and back and pull it off.
9. Carefully tap the shaving foil frame on
a flat surface.
10. Brush out the cutter block
the area below the cutter block.
11. N.B.: The shaving foil is a very delicate
part that must not be cleaned with the
brush.
12. We recommend that you put a drop of
light machine oil along the length of
the trimmer every 3 months.
13. Put the shaving foil frame back on and
snap it into place.
14. Replace the OptiTrim attachment
because it also serves as a protective
cap.
Note: Do not use the shaver head with a
damaged shaving foil.
Replacing the shaving parts
The shaving foil and the cutter block are
precision parts that wear out with the time.
Have the shaving foil frame and the cutter
block replaced when you notice a reduced
shaving performance even after cleaning
the shaver head.
Subject to change without notice.
This product conforms to the
European Directives EMC 89/336/
EEC and Low Voltage 73/23/EEC.
Please do not dispose of the
product in the household waste at
the end of its useful life. Disposal
can take place at a Braun Service
Centre or at appropriate collection
points provided in your country.
.
8b
on
8c
as well as
8d
13