Table of Contents
Advertisement
Interconnecting Tubing (cont.)
15 SEER Single Stage Heat Pump
Model #
Major
Capacity
Series
Voltage
18
C
J
ZP1 K E-PFV-13R
24
A
J
ZP21K5E-PFV-13R
30
A
J
ZP25K5E-PFV-13R
36
A
J
ZP31K6E-PFV-130
42
A
J
ZP36K5E-PFV-13R
48
A
J
ZP40K6E-PFV-130
60
A
J
ZP49K6E-PFV-130
36
A
C
ZP31K6E-TF5-130
42
A
C
ZP36K5E-TF5-13R
48
A
C
ZP40K6E-TF5-130
60
A
C
ZP49K6E-TF5-130
Suction Line Selection
Purpose of the suction line is to return superheated
vapor to the condensing unit from the evaporator.
Proper suction line sizing is important because it plays
an important role in returning oil to the compressor to
prevent potential damage to the bearings, valves, and
scroll sets. Also, an improperly sized suction line can
dramatically reduce capacity and performance of the
system. The procedure for selecting the proper suc-
tion line is as follows:
Name Plate
Factory
Oil Charge
Installed
Compressor
(oz)
CCH
21
N
21
N
25
N
21
N
42
N
42
N
42
Y
21
N
42
N
42
Y
42
Y
OUTDOOR UNIT LEVEL OR NEAR LEVEL TO INDOOR SECTION LINE SET
REFERENCE TABLE 2 FOR
MAXIMUM LENGTH LIMITATIONS
• The total amount of suction line needed
• Add all of the equivalent lengths associated with
!
ous page.
will equal your total equivalent length.
• Reference Table 2 to verify that the calculated
equivalent length falls within the compatibility region
of the chart.
• Verify Table 3 to verify the capacity difference is
compatible with the application.
Refrigerant Migration During
Off Cycle
Long line set applications can require a consider-
able amount of additional refrigerant. This additional
refrigerant needs to be managed throughout the entire
ambient operating envelope that the system will go
through during its life cycle. Off-Cycle migration is
where excess refrigerant condenses and migrates to
the lowest part of the system. Excessive build-up of
refrigerant at the compressor will result in poor reli-
ability and noisy operation during startup. This sec-
tion demonstrates the required accessories and unit
IDEALLY, LINE SET SLOPES AWAY
FROM OUTDOOR. VERIFY
SUB-COOLING PRIOR TO
THROTTLEING DEVICE, INSULATED
LIQUID LINE.
ST-A1219-01-01
INSTALLATION
-
15
Advertisement
Table of Contents
