Operating The Appliance; Preparing The Appliance; Select Programme/Switch On The Appliance; Placing Laundry Into The Drum - Siemens WU P Series Instruction Manual And Installation Instructions

1
Operating the
appliance
P reparing the appliance
O p e r a t i n g t h e a p p l i a n c e
The appliance was tested before
delivery. To remove residual water from
the test procedure, the first wash cycle
should be run without laundry using the
Drum clean programme.
~ "Before washing for the first time"
on page 18
Notes
Never switch on a damaged
■
appliance!
Inform customer service!
■
Insert mains plug.
1.
:
Warning
Riskof death from electric shock!
Risk of death if live parts are
touched.
– Never pull out the mains plug by
tugging the power cord.
– Insert/pull out the mains plug
with dry hands only.
Turn the tap on.
2.
Open the appliance door.
3.

Operating the appliance

Select programme/switch on
the appliance
If you have activated the
Note:
childproof lock, you must first deactivate
it before you can set a programme.
Use the programme selector to select
the required programme. The
programme selector can be rotated in
either direction.
The appliance is switched on.
The programme default settings for the
selected programme appear in the
display panel:
The maximum load and
■
the duration of the programme
■
(alternately)

Placing laundry into the drum

Insert the washing.
Close the door.
Notes
Unfold and load presorted items
■
of washing. Mix large and small
items. Washing items of different
size distribute themselves better
during the spin cycle. Individual
items of washing may cause
an unbalanced load.
Observe the maximum specified
■
load. Overfilling adversely affects the
washing result and promotes
creasing. Make sure that no items of
laundry are trapped between the
door and the rubber seal, and close
the door.
en
25