Start The Programme; Childproof Lock; Adding/Removing Laundry; Changing The Programme - Siemens WU P Series Instruction Manual And Installation Instructions

Start the programme

Press the A button. The indicator lamp
lights up and the program starts.
The display panel shows the Finish in
time while the program is running or the
program duration and the program
progress symbols once the wash cycle
has started.
Note: Foam detection
If the o symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next wash
cycle with the same load.
If you want to lock the program to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.

Childproof lock

(w)
You can lock the appliance to prevent
the settings you have set from being
changed inadvertently. To do this,
activate the childproof lock.
Touch and hold the rpm 0 and Finish
in û buttons at the same time to
activate/deactivate the childproof lock.
To activate the childproof lock:
After the programme starts, Touch and
hold the rpm 0 and Finish in û buttons
for 3 seconds.
w lights up: The childproof lock is
■
activated.
w flashes: The childproof lock is
■
active and the programme selector
has been adjusted.
When the programme ends, End
Note:
is displayed. The door is closed. w
and Õ symbols remain on to remind
you to deactivate the childproof lock.
To deactivate the childproof lock:
Operating the appliance
Touch and hold the rpm 0 and Finish
in û buttons until the symbol w
disappears.

Adding/removing laundry

After starting the programme, you can
add or remove laundry if necessary.
Touch the A button. The appliance
checks whether reloading is possible.
If the following appears on the Touch-
Display:
The symbol Õ disappears, reloading
■
is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
A button. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the A button.
1.
Select another programme.
2.
And touch the ‹ button again. The
3.
new programme starts from the
beginning.
en
27