Table of Contents
Advertisement
Cleaning and maintenance
en
Put the service flap back on, lock it
5.
into place and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 2 litre of
water into dispenser II and start the
Single spin programme.
The drain hose at the siphon
is blocked
Turn the programme selector to $
1.
Off. Pull out the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
32
Filter in the water supply is
blocked
Release water pressure in the supply
1.
hose:
a) Turn off the tap.
b) Select any programme (except
Rinse and Spin).
c) Select the A Start/Reload
button. Allow the programme to
run for approx. 40 seconds.
d) Turn the programme selector to
$ Off. The appliance is switched
off.
e) Pull out the mains plug.
Clean the filters:
2.
a) Disconnect the hose from the
tap.
Clean the filter with a small brush.
b) For standard and Aqua-Secure
models, clean the filter on the
rear of the appliance:
Disconnect the hose from the
rear of the appliance.
Use pliers to remove the filter and
then clean it.
Connect the hose and check for
3.
leaks.
Advertisement
Table of Contents
