Table of Contents
Advertisement
3
Faults and what to do
about them
E mergency release
F a u l t s a n d w h a t t o d o a b o u t t h e m
E.g. in the event of a power cut
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the appliance door can be
opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
and laundry.
If possible, leave it to cool down first.
Caution!
Risk when reaching into/gripping the
rotating drum!
You may injure your hands if you reach
into the drum while it is turning.
Information on the display panel
Display
Õ
|
E:18
Cause/Remedy
Flashes fast + warning signal: The door was opened and the water level is
■
too high. Close the door, continue the programme with A Start/Reload but-
ton or select Spin programme.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
Flashes (no water supply): Tap turned on? Filter in the water supply is
■
blocked?
~ "Filter in the water supply is blocked" on page 32
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
Is the drain pump blocked?
~ "Drain pump is blocked" on page 31
Is the drain hose at the siphon blocked?
~ "The drain hose at the siphon is blocked" on page 32
Faults and what to do about them
Do not reach into the drum when it is
turning.
Caution!
Water damage!
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
Switch off the appliance. Pull out the
1.
mains plug.
Drain the water
2.
Pull the emergency release
3.
downwards with a tool and release.
The door can then be opened.
.
en
33
Advertisement
Table of Contents
