Setup Of The Double Matrix Professional Soni C - Clearaudio Double Matrix Professional SONI C User Manual

User manual / Bedienungsanleitung
double matrix professional SONI C
3. Setup of the
Take the already assembled
packaging. Set it on a stable and horizontal surface (such as a desk or rack).
Please note that due to the weight of the record cleaning machine, the feet of the device can cause
marks on soft surfaces. Due to the warm air outlet on the bottom of the
SONIC
, the surface on which it rests should be heat resistant to a minimum of 60°C.
3.1 Connect to the mains supply
To avoid using an additional extension cable, place the
metres of an electrical wall outlet.
Connect the supplied mains cable first to the IEC socket on the back of the
SONIC
, and then to the electrical wall outlet. Press the switch on the IEC socket and position it to "I".
Please read the whole user manual before cleaning your first record.
Note: Voltages are referenced to EU countries w ith 230V mains pow er.
I n other countries the mains voltage and frequency may vary ( e.g. USA 115V/ 60Hz.)
The correct operating voltage can be found on the back of the device on the product
information label ( Fig. 1) .
Pic. 1: Product information label on the back
The mains cable supplied should be of the type appropriate for your country. Please ensure that the
mains voltage of your country also matches the mains voltage of the device. This information is also
on the product information label (see above). If it does not match, contact your Clearaudio dealer.
Page / Seite 6
double matrix professional SONIC
record cleaning machine from its
double matrix professional
double matrix professional SONIC
double matrix professional
© clearaudio electronic GmbH, 2019-04
within 2