Table of Contents
Advertisement
Chapter 2: Site Preparation and Installation
Initial Configuration
To assign IP addresses and perform other initial configuration tasks, refer to the
OmniAccess SafeGuard OS Administration Guide.
Troubleshooting
Table 9
provides suggestions for troubleshooting basic hardware issues that might arise
when you install the SafeGuard Controller.
The software documentation provides detailed troubleshooting instructions for operating
and configuration issues. If after reviewing the software documentation your trouble is
not resolved, consult the Alcatel-Lucent Technical Assistance Center.
Table 9
Troubleshooting Basic Hardware issues
Cable and Connectivity Issues
For this problem . . .
No link exists when the optical
cable is connected.
The SafeGuard Controller does not
have connectivity when the
copper cable is connected.
Port Issues
For this problem . . .
Ports are malfunctioning.
Management Console Issues
For this problem . . .
The SafeGuard Controller
management console displays
unreadable characters.
34
Take these actions. . .
Verify that you have used the correct cable for the port
■
type.
Clean the connectors, and reconnect the cable.
■
Try a new cable.
■
If you are using the factory default configuration, make
■
sure that the port has been enabled through the CLI.
Make sure that you are using the correct choice of
■
crossover or straight-through cable.
If the cable type is correct, check the connector
■
pinouts to verify that the cable is wired correctly.
Take these actions. . .
Remove and reinsert the affected SFP module.
■
For optical ports, clean the cable connectors, and
■
reconnect the cable.
Try a new cable.
■
Take these actions. . .
Check for an incorrect baud rate and make sure that the
baud rate for the terminal emulation software is set to 9600.
OmniAccess SafeGuard Controller Installation Guide
Advertisement
Table of Contents
