Figure 14 Connecting The Ethernet Management Port; Figure 15 Connecting The Serial Console Port - Alcatel-Lucent OmniAccess SafeGuard Installation Manual

Chapter 2: Site Preparation and Installation

Figure 14 Connecting the Ethernet Management Port

CST_012
Connect the serial console port using an RS-232 cable with a DB-9 connector, as shown in
Figure 15. The default settings for this port are 9600 baud, 8 data bits, 1 stop bit, and no
parity or flow control (9600 8-N-1 none). The default settings may be changed either in
the boot monitor or during system operation.

Figure 15 Connecting the Serial Console Port

CST_015
33
OmniAccess SafeGuard Controller Installation Guide