Installing The Safeguard Controller On A Table Or Shelf; Installing The Safeguard Controller In A Rack - Alcatel-Lucent OmniAccess SafeGuard Installation Manual

■ RS-232 (DB-9) configuration cable
■
Mounting accessories, including:
— Four rubber feet for installing the SafeGuard Controller on a table
— Two brackets for installing the SafeGuard Controller in a rack
— Six Phillips screws for attaching the brackets to the SafeGuard Controller
■
Disposable ESD wrist strap
■
SFP modules and cables as determined when the SafeGuard Controller was
ordered

Installing the SafeGuard Controller on a Table or Shelf

To install the SafeGuard Controller on a table or shelf, follow these steps:
1 Lift the controller carefully from the packing material and place it upside down
on a flat surface.
2 Locate the recessed areas on the bottom of the controller, and attach the four
rubber feet from the mounting kit.
3 Place the controller on a table or shelf close to an AC power source.
For the ACDC model, an additional 48-VDC power source should be available.
For instructions on connecting the power cords, see
Controller on page

Installing the SafeGuard Controller in a Rack

You can attach the rack-mounting brackets to the SafeGuard Controller in either of the
following positions:
■
At the front of the controller to install it in a four-post rack
■
At the middle of the controller to install it in a two-post (telco-type) rack
OmniAccess SafeGuard Controller Installation Guide
NOTE: You must provide rack-mounting screws appropriate to your
equipment rack and the cable for use with the DC terminal plug.
29.
Chapter 2: Site Preparation and Installation
Connecting Power to the SafeGuard
25