Safeguard Controller Rear Panel; Figure 4: Safeguard Controller Rear Panel-Dual Ac Power Supplies; Figure 5: Safeguard Controller Rear Panel-Ac And Dc Power Supplies - Alcatel-Lucent OmniAccess SafeGuard Installation Manual

depending on the speed and duplex settings of the attached interfaces. If a specific speed
for the interface is important, we recommend that you specify the speed of the interface
using the command line interface (CLI). Auto-negotiation is available on the 10/100/
1000 ports. Half-duplex operation is supported only at the 10/100 speed.

SafeGuard Controller Rear Panel

The rear panel of the SafeGuard Controller includes management ports, a compact flash
slot, and power connectors. The SafeGuard Controller is available with dual AC power
supplies (Figure
Figure 4
Ethernet RS-232
RJ-45 (DB-9)
Figure 5
Ethernet RS-232
RJ-45 (DB-9)
The SafeGuard Controller management ports are:
■
One RJ-45 10/100 BASE-T Ethernet port for out-of-band IP-based management
■
One RS-232 management port (male DB-9, DTE) to access the CLI
The compact flash slot provides a way to store configuration files.
The SafeGuard Controller provides two power input connectors, either two AC
connectors or an AC and a DC connector. Although a single power connection is
adequate to operate the SafeGuard Controller, connecting both power supplies provides
backup power that can prevent unscheduled downtime.
OmniAccess SafeGuard Controller Installation Guide
4) or one AC power supply and one DC power supply
SafeGuard Controller Rear Panel—Dual AC Power Supplies
Compact Ground
flash screw
SafeGuard Controller Rear Panel—AC and DC Power Supplies
Compact Ground
flash screw
Chapter 1: Overview of the SafeGuard Controller
AC input
DC input
(Figure 5).
Ground AC input
screw
CST_002
Ground AC input
screw
CST_022
17